Configuration When The Remote Gateway Uses A Dynamic Ip Address; Configuration Of The Rvl200; Configuration Of The Rv016 - Cisco RV016 User Manual

Appendix C
Configuration when the Remote Gateway
Uses a Dynamic IP Address
This example assumes the Remote Gateway is using a
dynamic IP address. If the Remote Gateway uses a static
IP address, refer to "Configuration when the Remote
Gateway Uses a Static IP Address. "
RV016
Dynamic IP: B.B.B.B with
Domain Name: www.abc.com
LAN: 192.168.1.1
Gateway-to-Gateway IPSec VPN Tunnel - Remote Gateway Using
Dynamic IP
NOTE:
Each computer must have a network
adapter installed.

Configuration of the RVL200

Follow these instructions for the first VPN Router,
designated RVL200. The other VPN Router is designated
the RV016.
1. Launch the web browser for a networked computer,
designated PC 1.
2. Access the web-based utility of the RVL200. (Refer to
the User Guide of the RVL200 for details.)
IPSec VPN tab.
3. Click the
Gateway to Gateway tab.
4. Click the
5. Enter a name in the Tunnel Name field.
6. For the VPN Tunnel setting, select
7. For the Local Security Gateway Type, select
The WAN IP address (A.A.A.A) of the RVL200 will be
automatically detected.
For the Local Security Group Type, select Subnet. Enter
the RVL200's local network settings in the IP Address
and Subnet Mask fields.
10/100 16-Port VPN Router
RVL200
WAN: A.A.A.A
LAN: 192.168.5.1
Enable.
IP Only.
Gateway-to-Gateway VPN Tunnel
RVL200 IPSec VPN Settings
8. For the Remote Security Gateway Type, select
Then select IP by DNS Resolved. Enter the RV016's
domain name in the field provided.
9. For the Remote Security Group Type, select
Enter the RV016's local network settings in the IP
Address and Subnet Mask fields.
10. In the IPSec Setup section, select the appropriate
encryption, authentication, and other key management
settings.
11. In the Preshared Key field, enter a string for this key, for
example, 13572468.
RVL200 IPSec Setup Settings
12. If you need more detailed settings, click
Settings. Otherwise, click Save Settings and proceed
to the next section, "Configuration of the RV016. "

Configuration of the RV016

Follow similar instructions for the RV016.
1. Launch the web browser for a networked computer,
designated PC 2.
2. Access the web-based utility of the RV016. (Refer to
"Chapter 4: Advanced Configuration" for details.)
VPN tab.
3. Click the
Gateway to Gateway tab.
4. Click the
5. Enter a name in the Tunnel Name field.
6. Select the appropriate Interface,
IP Only.
Subnet.
Advanced
WAN1 or WAN2.
68