Rack-Mount Placement; Cable Connections - Cisco RV016 User Manual

Chapter 3
5. Place the wall-mount slots over the screws and slide
the Router down until the screws fit snugly into the
wall-mount slots.

Rack-Mount Placement

The Router includes two brackets and eight screws for
mounting on a standard-sized, 19-inch high rack. Observe
the following guidelines:
Elevated Operating Ambient
•
or multi-unit rack assembly, the operating ambient
temperature of the rack environment may be greater
than room ambient. Therefore, consideration should
be given to installing the equipment in an environment
compatible with the maximum ambient temperature
(Tma) specified by the manufacturer.
Reduced Air Flow Installation of the equipment
•
in a rack should be such that the amount of air flow
required for safe operation of the equipment is not
compromised.
Mechanical Loading Mounting of the equipment in
•
the rack should be such that a hazardous condition is
not achieved due to uneven mechanical loading.
Circuit Overloading
Consideration should be given
•
to the connection of the equipment to the supply
circuit and the effect that overloading of the circuits
might have on overcurrent protection and supply
wiring. Appropriate consideration of equipment
nameplate ratings should be used when addressing
this concern.
Reliable Earthing Reliable earthing of rack-mounted
•
equipment should be maintained. Particular attention
should be given to supply connections other than
direct connections to the branch circuit (e.g., use of
power strips).
To rack-mount the Router in any standard 19-inch rack,
follow these instructions.
1. Place the Router on a hard flat surface with the front
panel faced towards your front side.
2. Attach a rack–mount bracket to one side of the Router
with the supplied screws and secure the bracket
tightly.
7
6
4 5
3
2
1
13
11 12
10 2 1
9 3
4
5
7 6
Attach the Brackets
10/100 16-Port VPN Router
If installed in a closed
1
2
8
13 3
4
12
5
11
10 6
9 7
3. Repeat step 2 to attach the other bracket to the
opposite side.
4. After the brackets are attached to the Router, use
suitable screws to securely attach the brackets to any
standard 19-inch rack.
8
6 7
5
4
2 3
1
13
12
11 1
9 10 2
3
5 4
6
7
Mount in Rack

Cable Connections

To connect network devices to the Router, follow these
instructions:
1. Before you begin, make sure that all of your hardware
is powered off, including the Router, computers,
switches, and cable or DSL modem.
2. Connect one end of an Ethernet network cable to one
of the numbered local ports (white print). Connect the
other end to an Ethernet port on a network device,
such as a computer or switch.
Repeat this step to connect more computers or other
network devices to the Router.
Connect to LAN Port 1
Installation
1
2
13 3
12 4
11 5
10 6
7
9
5