Configuration Of Pc 1 And Pc 2; Configuration When Both Gateways Use Dynamic Ip Addresses; Configuration Of The Rvl200 - Cisco RV016 User Manual

Appendix C
Enable.
7. Select
8. For the Local Security Gateway Type, select
The WAN IP address (B.B.B.B) of the RV016 will be
automatically detected.
For the Local Security Group Type, select Subnet. Enter
the RV016's local network settings in the IP Address and
Subnet Mask fields.
RV016 VPN Settings
9. For the Remote Security Gateway Type, select
Enter the RVL200's WAN IP address in the IP Address
field.
10. For the Remote Security Group Type, select
Enter the RVL200's local network settings in the IP
Address and Subnet Mask fields.
11. In the IPSec Setup section, select the appropriate
encryption, authentication, and other key management
settings. (These should match the settings of the
RVL200.)
12. In the Preshared Key field, enter a string for this key, for
example, 13572468.
RV016 IPSec Setup Settings
13. If you need more detailed settings, click
Settings. Otherwise, click Save Settings.

Configuration of PC 1 and PC 2

Verify that PC 1 and PC 2 can ping each other (refer to
Windows Help for more information). If they can ping
each other, then the VPN tunnel is configured correctly.
10/100 16-Port VPN Router
Configuration when Both Gateways Use
IP Only.
Dynamic IP Addresses
This example assumes both Gateways are using dynamic IP
addresses. If the Remote Gateway uses a static IP address,
refer to "Configuration when the Remote Gateway Uses
a Static IP Address. " If only the Remote Gateway uses a
dynamic IP address, refer to "Configuration when the
Remote Gateway Uses a Dynamic IP Address. "
Gateway-to-Gateway IPSec VPN Tunnel - Both Gateways Using
IP Only.
Subnet.

Configuration of the RVL200

Follow these instructions for the first VPN Router,
designated RVL200. The other VPN Router is designated
the RV016.
1. Launch the web browser for a networked computer,
designated PC 1.
2. Access the web-based utility of the RVL200. (Refer to
the User Guide of the RVL200 for details.)
3. Click the
4. Click the
5. Enter a name in the
6. For the VPN Tunnel setting, select
7. For the Local Security Gateway Type, select
The WAN IP address (A.A.A.A) of the RVL200 will be
automatically detected.
For the Local Security Group Type, select Subnet. Enter
Advanced
the RVL200's local network settings in the IP Address
and Subnet Mask fields.
Gateway-to-Gateway VPN Tunnel
RV016
Dynamic IP: B.B.B.B with
Domain Name: www.abc.com
LAN: 192.168.1.1
Dynamic IP
NOTE:
Each computer must have a network
adapter installed.
IPSec VPN tab.
Gateway to Gateway tab.
Tunnel Name field.
RVL200
Dynamic IP: A.A.A.A with
Domain Name: www.xyz.com
LAN: 192.168.5.1
Enable.
IP Only.
69