Download Print this page
DeWalt DCPS330 Manual
Hide thumbs Also See for DCPS330:

Advertisement

Quick Links


WARNING: To reduce the risk of injury, wear protective
gloves and boots when working with wet concrete.

WARNING: Do not use accessories which are
not specifically designed and specified by the tool
manufacturer. Just because the accessory can be attached
to your power tool, it does not assure safe operation.
ALWAYS avoid wearing jewelry or loose fitting clothes that
may snag on the controls or moving parts as this can cause
serious injury.
NEVER operate this equipment when not feeling well due to
fatigue, illness or when under medication.
NEVER operate this equipment under the influence of drugs
or alcohol.
ALWAYS clear the work area of any debris, tools, etc.
that would constitute a hazard while the equipment is in
operation.
DO NOT use the equipment for any purpose other than its
intended purposes or applications.
The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V .......................... volts
Hz ........................hertz
min ......................minutes
or DC ......direct current
....................... Class I Construction
(grounded)
.../min .............. per minute
BPM .................... beats per minute
IPM ..................... impacts per minute
OPM .................... oscillations per minute
RPM .................... revolutions per minute
sfpm ................... surface feet per minute
SPM .................... strokes per minute
A ......................... amperes
W ........................ watts
Wh ...................... watt hours
Ah ....................... amp hours
or AC ........... alternating current
Batteries and Chargers
The battery pack is not fully charged out of the carton.
Before using the battery pack and charger, read the
safety instructions below and then follow charging
procedures outlined. When ordering replacement battery
packs, be sure to include the catalog number and voltage.
READ ALL INSTRUCTIONS
SAVE ALL WARNINGS AND
INSTRUCTIONS FOR FUTURE REFERENCE
Important Safety Instructions for All
Battery Packs

WARNING: Read all safety warnings, instructions,
and cautionary markings for the battery pack,
charger and product. Failure to follow the
or AC/DC .... alternating or
direct current
...................... Class II Construction
(double insulated)
n o ....................... no load speed
n ......................... rated speed
PSI....................... pounds per square inch
...................... earthing terminal
..................... safety alert symbol
..................... visible radiation–
do not stare into
the light
..................... wear respiratory
protection
..................... wear eye protection
..................... wear hearing
protection
..................... read all documentation
..................... do not expose to rain
warnings and instructions may result in electric
shock, fire and/or serious injury.
Use power tools only with specifically designated
battery packs. Use of any other battery packs may create
a risk of injury and fire.
Under abusive conditions, liquid may be ejected from
the battery; avoid contact. If contact accidentally
occurs, flush with water. If liquid contacts eyes,
additionally seek medical help. Liquid ejected from the
battery may cause irritation or burns.
Do not charge or use the battery pack in explosive
atmospheres, such as in the presence of flammable
liquids, gases or dust. Inserting or removing the battery
pack from the charger may ignite the dust or fumes.
NEVER force the battery pack into the charger or tool.
DO NOT modify the battery pack in any way to fit into
a non‑compatible charger as battery pack may rupture
causing serious personal injury.
Charge the battery packs only in D
DO NOT splash or immerse in water or other liquids.
DO NOT allow water or any liquid to enter battery pack.
Do not store or use the tool and battery pack in
locations where the temperature may reach or
exceed 104 °F (40 °C) (such as outside sheds or metal
buildings in summer). For best life, store battery packs in
a cool, dry location.
NOTE: Do not store the battery packs in a tool with
the trigger switch locked on. Never tape the trigger
switch in the ON position.
Have servicing performed by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the product is maintained.
Do not incinerate the battery pack even if it is severely
damaged or is completely worn out. The battery pack
can explode in a fire. Toxic fumes and materials are created
when lithium‑ion battery packs are burned.
Do not expose a battery pack or appliance to fire or
excessive temperature. Exposure to fire or temperature
above 265 °F (130 °C) may cause explosion.
Follow all charging instructions and do not charge the
battery pack or appliance outside of the temperature
range specified in the instructions. Charging improperly or
at temperatures outside of the specified range may damage
the battery and increase the risk of fire.
If battery contents come into contact with the skin,
immediately wash area with mild soap and water. If
battery liquid gets into the eye, rinse water over the open
eye for 15 minutes or until irritation ceases. If medical
attention is needed, the battery electrolyte is composed of a
mixture of liquid organic carbonates and lithium salts.
Contents of opened battery cells may cause
respiratory irritation. Provide fresh air. If symptoms
persist, seek medical attention.
Battery liquid may be flammable if exposed to spark
or flame.
Never attempt to open the battery pack for any
reason. If the battery pack case is cracked or
ENglish
WALT chargers.
e
7

Advertisement

loading
Need help?

Need help?

Do you have a question about the DCPS330 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for DeWalt DCPS330

  • Page 1 ENglish WARNING: To reduce the risk of injury, wear protective warnings and instructions may result in electric shock, fire and/or serious injury. gloves and boots when working with wet concrete. WARNING: Do not use accessories which are Use power tools only with specifically designated •...
  • Page 2: Storage Recommendations

    ENglish damaged, do not insert into the charger or tool. Do shipping the D WALT POWERshiFT® Battery Pack not crush, drop or damage the battery pack. Do not use a Your D WALT POWERSHIFT® battery pack of 600 Wh or less battery pack or charger that has received a sharp blow, been has a shipping card that should be used when shipping dropped, run over or damaged in any way (e.g., pierced with...
  • Page 3: Battery Recycling

    300 Wh and need to be recycled in a different a program than other lower energy rechargeable battery packs. Please see the following website for more information regarding battery recycling: dewalt.com/ Not Recommended high‑energy‑battery‑info. Do not place any object on top of the charger or •...
  • Page 4: Electronic Protection System

    ENglish 4. The completion of charge for Stage 1 or Stage 2 will be b. Check to see if receptacle is connected to a light indicated by the stage's light remaining ON continuously. switch which turns power off when you turn out The battery pack is fully charged when both Stage 1 and the lights;...
  • Page 5 ENglish Adjusting Handle Bars Attaching Triangular Bar Adaptor (Fig. K) To attach a triangular bar to the screed leveler, the triangular Adjusting Handle Height (Fig. F) bar adaptor must first be attached. 1. Loosen the height adjustment clamps 1. Ensure the locknut housing is not in place by 2.
  • Page 6: Installing And Removing The Battery Pack

    ENglish OPERATION a. If wet screeding, lift the product until the rear edge of the bar is slightly lifted WARNING: To reduce the risk of serious personal 6. Once the desired section is complete, move to the next injury, turn unit off and remove the battery pack section, allowing 12 inches (30.5 cm) of overlap on the before making any adjustments or removing/ previous section of the concrete surface.
  • Page 7: Register Online

    4. Once in place, tighten the handle angle/width is required under the Federal Consumer Safety Act. adjustment screws with the hex wrench • Register online at www.dewalt.com/account‑login. secure handles. Three‑Year Limited Warranty 5. When the trigger play is out of specification, adjust the throttle cable as shown in Fig.
  • Page 8 Le support de carottage DCPS330 POWERSHIFT® Power Screed est compatible avec les batteries FLEXVOLT® mentionnées lorsque ces batteries sont placées dans l'adaptateur DCAFVPS FLEXVOLT®. El soporte de perforación hueca DCPS330 POWERSHIFT® Power Screed es compatible con las baterías FLEXVOLT® mencionadas cuando esas baterías se colocan en el adaptador DCAFVPS FLEXVOLT®.