Wallbox Commander 2s Installation Manual page 3

Electric Drill 8 mm bits
Pencil
Phillips Screwdriver
Torx T9
Spirit Level
Measuring Tape
Utility Knife
Cutting Pliers
ø8 x 40 mm wall anchors
ø6 x 50 mm screws
ø5 x 40 mm screws
ø3 x 6 mm screws
1-exit M25 grommet
Protective cap
Opening tool
4. Drilling
Using the drilling template provided, mark three drilling points, then use the drill to
complete the procedure and insert the wall anchors.
Do not fix the charger to the wall if you opt for a rear connection. Check section 7
for details on how to fix the charger on the wall in case of a rear connection.
3/9