Parts And Components; Before Use - cecotec CONGA 9590 SPIN REVOLUTION ULTRA POWER Instruction Manual

ENGLISH

1. PARTS AND COMPONENTS

Fig. 1.1:
1. Back Home button
2. Start/Pause button
3. Laser sensor
4. Reset button
5. Bumper
6. Top cover
7. Mixed-tank release tab
8. Fall-detection sensors
9. Side brush
10. Drive wheels
11. Spin mops
12. Charging terminals
13. Omnidirectional wheel
14. Main brush
15. Battery
Robot vacuum cleaner accessories. Fig. 1.2:
1. Charging base
2. Power cable
3. Bracket with mop
4. Instruction manual
5. Self-cleaning brush
6. Side brush
Mixed tank. Fig. 2:
1. High-efficiency filter cover
2. Sponge filter
3. High-efficiency filter
4. Charging terminals
5. Water inlet
6. Water tank
Please note
The graphics in this manual are schematic representations and may not exactly match the
appliance.
66
CONGA 9590 SPIN REVOLUTION ULTRA POWER

2. BEFORE USE

- This robot vacuum cleaner includes a package designed to protect it during transport.
Take the robot vacuum cleaner out of the box. Keep the original box and other elements
in a safe place, as this will help you prevent damage to the robot vacuum cleaner when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or not in good condition, contact the official Cecotec Technical Support
Service immediately.
Warnings
- Remove all objects around the robot vacuum cleaner such as clothing, papers, cables,
curtains, or other fragile objects which may block or slow down the operation of the robot
vacuum cleaner. Fig. 3
- If the room to be cleaned is near a balcony or stairs, a physical barrier should be placed to
prevent the robot vacuum cleaner from falling and getting damaged, thus ensuring safe
operation. Fig. 4
- Do not use the robot vacuum cleaner to vacuum up liquids. Fig. 5
- Direct exposure to sunlight or heavy light contrasts may affect the correct operation of the
sensors. If this happens, the robot vacuum cleaner will cease operation. Move it to a new
location for it to start operating again.
Installing the robot vacuum cleaner and charging base
1. Place the charging base against a wall and leave a minimum free space of 1.5 metres to the
front and 0.5 metres to each side. Fig. 6.
2. Connect the charging base to a power socket. Wind and store the remaining cable to
prevent accidents.
3. Install the side brush. Fig. 7
4. Press and hold the Start/Pause button for a few seconds.
5. When the indicator light turns on, place the robot vacuum cleaner in the charging base and
make sure the charging terminals on the robot match those on the charging base. If the
indicator light is flashing blue, it means the battery is not completely charged. To ensure
the maximum cleaning time, wait until the indicator light turns into steady blue, as this
indicates that the battery is fully charged, and that the robot vacuum cleaner is ready to
clean.
Note
- Take the robot vacuum cleaner to the charging base if the battery is low. The robot vacuum
cleaner may not turn on if battery is too low.
- The robot vacuum cleaner will automatically turn on when placed on the charging base.
- The robot vacuum cleaner cannot be turned off during recharge.
ENGLISH
CONGA 9590 SPIN REVOLUTION ULTRA POWER
67