Winding/Installing The Bobbin; Bobbin Precautions; Winding The Bobbin - Brother CS-8150 Operation Manual

GETTING READY ———————————————————————————————————————————————————

Winding/Installing the Bobbin

This section describes how to wind the thread onto the bobbin, and then insert the bobbin thread.

Bobbin precautions

Be sure to observe the following precautions concerning the bobbin.
CAUTION
●
Only use the bobbin (part code: SA156, XA5539-151) designed specifically for this sewing
machine. Use of any other bobbin may result in injuries or damage to the machine.
●
The enclosed bobbin was designed specifically for this sewing machine. If bobbins from older
models are used, the machine will not operate correctly. Use only the enclosed bobbin or
bobbins of the same type (part code: SA156, XA5539-151).

Winding the bobbin

Wind the thread around the bobbin to prepare the bobbin thread.
1 Turn on the sewing machine.
2 Open the bobbin winder cover at the top on
the right side of the sewing machine.
18
Actual size
11.5 mm
(7/16 inch)
This model Older model
3 Swing up the bobbin thread spool pin.
Move the bobbin thread spool pin up as far as
possible.
1 Bobbin thread spool pin
4 Place the bobbin on the bobbin winder shaft
so that the spring on the shaft fits into the
notch in the bobbin.
1
2
1 Notch
2 Bobbin winder shaft spring
1