Darning - Brother CS-8150 Operation Manual

Darning

Fabric that has been torn can be darned.
Darning is sewn as shown below.
1 Reinforcement stitching
Determine the desired length of the darning.
1
Set the button guide plate on buttonhole foot
"A" to the desired length. (The distance
between the markings on the presser foot scale
is 5 mm (3/16 inch).)
2
4
1 Presser foot scale
2 Length of darning
3 5 mm (3/16 inch)
4 7 mm (1/4 inch)
• A bar tack with a maximum length of about
28 mm (1-1/8 inch) can be sewn.
2 Attach buttonhole foot "A".
• For details, refer to "Replacing the presser
foot" (page 41).
52
3 Select stitch
• For details, refer to "Selecting stitching"
(page 66).
1
3
53
or .
1
Position the fabric so that the needle is 2 mm
4
(1/16 inch) in front of the area to be darned,
and then lower the presser foot lever.
1
1 Tear
2 2 mm (1/16 inch)
Pass the upper thread down through the hole
in the presser foot.
• When lowering the presser foot, do not push
in the front of the presser foot, otherwise the
darning will not be sewn with the correct
size.
1 Do not reduce the gap.
Reinforcement Stitching
1
2
1
97