Thread The Needle Manually (Without Using The Needle Threader) - Brother CS-8150 Operation Manual

4 Thread the thread cassette with the thread
from the spool on the extra spool pin.
• For more details, refer to "Loading the spool
into the thread cassette" (page 25).
5 Insert the thread cassette (with the extra spool
pin attached) into the thread cassette
compartment.
Use both hands to press down on both sides of
the extra spool pin.
At the same time that the thread cassette is
inserted, the needle is threaded.
The extra spool pin is now installed.
Thread the needle manually
(without using the needle threader)
When using special thread, thread with a thickness
of 130/20 or less, the wing needle or the twin needle
which cannot be used with the needle threader,
thread the needle as described below.
1 Remove the needle.
• Refer to "Replacing the needle" (page 38).
• When using the wing needle, the twin
needle or thread that cannot be used with
the needle threader, be sure to remove the
needle, otherwise the machine may be
damaged.
Check that the thread cassette indicator is lit
2
up in green, and then insert the thread
cassette into the thread cassette
compartment.
• For details, refer to
(page 28).
Pass the thread through the needle bar
thread hook.
1 Needle bar thread hook
3 Install a needle.
• Refer to "Replacing the needle" (page 38).
4 Pass the thread through the eye of the needle
from front to back.
1 2
through
1
Upper Threading 31