Brother HL-3040CN Network User's Manual page 109

h
Using a computer that is on the network, type "http://access point's IP address/" into your browser.
(Where "access point's IP address" is the IP address of the device that is used as the Registrar
the WPS (Wi-Fi Protected Setup) setting page and input the PIN which the LCD shows in g to the
Registrar and follow the on-screen instruction.
1
The Registrar is normally the access point/router.
Note
The setting page is different, depending on the brand of access point/router. See the instruction manual that
came with your access point/router.
If you are using your Windows Vista
Note
To use a Windows Vista
the instruction manual that came with your access point/router.
1 Click the button and then Network.
2 Click Add a wireless device.
3 Choose your machine and click Next.
4 Input the PIN from the printed page and then click Next.
5 Choose your network that you want to connect to, and then click Next.
6 Click Close.
i
If the LCD shows Connected, the machine has successfully connected to your access point/router. You
can now use your machine in a wireless network.
If the LCD shows Connection Fail, the machine has not successfully connected to your access
point/router, or the entered PIN code is invalid. Make sure you enter the correct PIN code, and try starting
from f again. If the same message is indicated again, reset the print server back to its factory default
settings and try again. For resetting, see Reset the network settings to the factory default on page 122.
If the LCD shows No Access Point, the machine has detected no access point/router on your
network. Make sure you place the Brother machine as close to the network access point/router as
possible with minimal obstructions, and try starting from f again. If the same message is indicated
again, reset the print server back to its factory default settings and try again. For resetting, see Reset the
network settings to the factory default on page 122.
You have completed the wireless setup. To install the printer driver, Go to step a on page 100
®
for Windows or page 104 for Macintosh.
Wireless configuration using the PIN Method of Wi-Fi Protected Setup (For HL-3070CW)
®
computer as a Registrar, follow the instructions below.
®
computer as a Registrar, you need to register it to your network in advance. See
1
.) Go to
7
99