3.
All four control heads can select ISO mode at the same time.
4.
If pilot & copilot are in ISO mode, then the OBS 1 & OBS 2 can only
select ISO or CRW
If pilot & copilot are in CRW mode, then the OBS 1 & OBS 2 can only
select ISO or CRW
While the pilot & copilot are in either ISO or CRW mode then the OBS 1
and OBS 2 has the "cabin call" feature, either by pressing external CALL
switch or pressing the ACK button on their control head.
Remote ICS Mode Control
An optional external switch can act as a remote intercom mode selector for
the Pilot Control Head. Pressing the switch will increment the intercom
mode selector from ISO-ALL-CRW-ISO-ALL, etc. each time the button is
pressed.
Speaker operation (9)
To activate the cockpit speaker, press the SPR button. This will
place all received audio from that control head (CTL45x) over the
cockpit speaker.
Bluetooth® connection
The PAC45J has an internal Bluetooth module, no external boxes required,
but external antenna will be required. The audio controller is always
"discoverable," so you just need to search for the PAC45J from your Blue-
tooth-equipped phone or music source. Default access code is not required.
Once the PAC45J has been "paired" with your Bluetooth device, the TEL
distribution will act as described below.
Pairing Bluetooth® devices
The PAC45J can be paired with up to eight individual devices, but
will only connect to one at a time. When that number is exceeded,
the PAC45J will drop a device to allow the new device to
be added.
If the audio controller is turned on before the Bluetooth device, you
will have to manually connect from your Bluetooth device.
Otherwise once paired, the audio controller should connect
automatically.
Hint, if your devices are not recognized by the PAC45J, you may need to
reset the Bluetooth module, Press and hold HRTF and ICS buttons for more
than three (>3) seconds, then 'forget" the PAC45J from your device and re
-pair.
PAC45J Pilot Guide
Revision 1
202-045-2200
Page 9
Need help?
Do you have a question about the PAC45J and is the answer not in the manual?
Questions and answers