Bizfon 2000 Administrator's Manual page 65

Bizfon Manual II: Administrator's Guide
The SIP Trunk Settings page is used to enable the Bizfon as a
slave or master device for SIP trunking. The page consists of
the following components:
The Enable Trunks to Slave Devices checkbox enables the
Bizfon as a master device and allows you to configure the SIP
trunks to the slave Bizfons. When this checkbox is enabled the
Trunks to Slave Devices table needs to be configured.
The link Trunks to Slave Devices moves you to the page
where a list of slave devices needs to be defined.
The Trunks to Slave Devices page consists of a table where
slave devices are listed with the corresponding authentication
parameters.
Add functional button leads to the Add Entry page where a new
slave device parameters needs to be provided.
The Add Entry page consists of the following components:
The SIP Trunk Name text field requires the trunk name for the
corresponding connection. System suggests you to start the SIP
trunk name with the "SIP_Trunk_" words, according to the
automatic prefix used for the SIP trunks on the Bizfon, however
this is not mandatory.
The User Name text field requires the authentication user
name. The field in front of this text field displays the default non-
editable prefix for SIP trunks: "SIPTrunk_".
The Password text field requires the authentication password.
Please Note: The User Name and Password should match
both on master and slave Bizfons for the successful SIP trunk
establishment.
The Symmetric NAT checkbox should be selected when the
slave Bizfon is located behind the symmetrical NAT.
The Enable Trunks to Master Devices checkbox enables the
Bizfon as a slave device and allows connecting to the master
Bizfon via SIP trunk. When this checkbox is enabled the Trunks
to Master Devices table needs to be configured.
The link Trunks to Master Devices moves you to the page
where a list of master devices needs to be defined.
The Trunks to Master Devices page consists of a table where master devices are listed with the corresponding authentication parameters.
Add functional button leads to the Add Entry page where a new master device parameters needs to be provided.
Bizfon2000 and Bizfon4000 (SW Version 4.1.x)
Fig. II-120: SIP Trunk Settings page
Fig. II-121: SIP Trunk Settings – Trunks to Slave Devices page
Fig. II-122: SIP Trunk Settings – Trunks to Slave Devices – Add Entry page
Fig. II-123: SIP Trunk Settings – Trunks to Master Devices page
Administrator's Menus
65