Networking Tools - Bizfon 2000 Administrator's Manual

Bizfon Manual II: Administrator's Guide
The second page of Firmware update has a Browse
button used to browse the image file, and the Specify
Image text field that will display the selected image
filename.
Pressing Save will start uploading the image file to the
board and the next page will display results and
verification of the image being burned.
This page displays non-editable information about the
image validity. The Image Check field will display
"invalid" if the image does not correspond to the
hardware version.
The Current Software Version field shows the old
software version. The New Software Version field
shows the new version of the software image.
This page needs to be confirmed in order to continue
image updating. If you are sure that the image version is
appropriate for your device press Save.
If you have confirmed the firmware version, a new page
with firmware update progress will be displayed next.
There are no functions available on this page, just
information about the firmware update procedure. At
some point the connection with the device is being lost
and you need to wait until the firmware will be burned on
the Bizfon.
You will not be automatically redirected to the Login
page. To access the Bizfon's Web GUI, you need to
connect Bizfon again and login.
Attention: After the firmware update, all IP phones
attached to the Bizfon should be restarted.

Networking Tools

The Networking Tools page provides the possibility to check the Internet connection.
Ping sends four ICMP (Internet Control Message Protocol) requests with a default size of 64 bytes to the destination (IP address or host name)
specified in the text field Ping Target. The response times are logged, and the round trip time (the time required from being sent until being received
again) is measured. The minimum and maximum round trip time and its average as well as the percentage of lost and of received frames results are
displayed in the lower area of the page.
Traceroute checks the Internet connection by triggering the routers (hops) that are passed to reach the destination specified in the Traceroute
Target text field. Trace routing gives feedback on the routers passed by packets on the way toward the destination and the round trip delay of
packets to these routers.
Bizfon2000 and Bizfon4000 (SW Version 4.1.x)
Administrator's Menus
Fig. II-44: Firmware Update page 2
Fig. II-45: Firmware Check page
Fig. II-46: Firmware Update page
27