Regulatory Information; Fcc Supplier's Declaration Of Conformity - iRobot Roomba Combo 2 Essential Quick Start And Safety Manual

Regulatory information

FCC SUPPLIER'S DECLARATION OF CONFORMITY

iRobot Corporation
EN
Roomba Combo® robot
Contains FCC ID: 2AC7Z-ESPS3WROOM1 and contains IC: 21098-ESPS3WROOM1
This device complies with part 15 of the FCC Rules and CAN ICES-003(B) /
NMB-003(B).
Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not
cause interference, and (2) This device must accept any interference, including
interference that may cause undesired operation of the device.
Changes or modifications not expressly approved by iRobot Corporation could
void the user's authority to operate the equipment.
• This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules as well as
CAN ICES-003(B) / NMB-003(B) Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference to radio communication will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
9 For more information, visit global.irobot.com
Roomba Combo® robot model: RCC-Y1
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• Under Industry Canada regulations, this radio transmitter may only operate
using an antenna of a type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential radio interference to other
users, the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than the necessary for
successful communication.
• FCC Radiation Exposure Statement: This product complies with FCC §2.1091(b)
for mobile device RF exposure limits, set forth for an uncontrolled environment
and is safe for the intended operation as described in this manual. Per FCC
requirements, maintain a distance of more than 8 inches (20 cm) between any
person and the host device (Roomba robot).
• ISED Radiation Exposure Statement: This product complies with the Canadian
Standard RSS-102 for mobile device RF exposure limits, set forth for an
uncontrolled environment and is safe for the intended operation as described
in this manual. Per ISED requirements, maintain a distance of more than 8
inches (20 cm) between any person and the robot.
iRobot Corporation, 8 Crosby Drive, Bedford, MA 01730 USA
https://global.irobot.com
For battery recycling go to call2recycle.org or call
1-800-822-8837.