Specification; Notification Of Compliance - Reolink RLC-843WA Quick Start Manual

settings again.
If these won't work, contact Reolink Support at https://support.reolink.
com/.
Picture is not Clear
If the picture from the camera is not clear, please try the following solu-
tions:
• Check the camera dome cover for dirt, dust or spiderwebs, and clean
the dome cover with a soft, clean cloth. The dust-absorber included in the
package is recommended.
• Point the camera to a well-lit area, as the lighting condition will affect
the picture quality a lot.
• Upgrade the firmware of your camera to the latest version.
• Restore the camera to factory settings and check out again.

Specification

Dimension: Φ132.7 x 98.3 mm
Weight: 753.7g
Operating Temperature: -10°C~+55°C (14°F~131°F)
For more specifications, visit https://reolink.com/.
11 English

Notification of Compliance

FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note:
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
English 12