Safety And Preparation For Use - SpectraDynamics HPDA15-RM-B Operating Manual

Safety and Preparation for Use

CAUTION!
Voltages capable of causing injury or death are present in this instrument. Use
extreme caution whenever the instrument cover is removed.
Line Voltage
This instrument has been setup to operate on 110 to 120 VAC and a line
frequency of 50 to 60 Hz. The unit can be converted to operate on a line voltage
of 220 to 240 VAC. For this option please contact SDI.
Fuse
A 0.50 Ampere 250V slow-blow fuse is used for 110 to 120 VAC operation.
Only replace fuses with the same type and specifications.
Line Cord
The instrument has a detachable, three wire power cord for connection to a
grounded power source. The enclosure of the unit is directly connected to the
outlet ground to protect against electrical shock. Always use an outlet with a
protective ground and do not disable this safety mechanism.
Service
Do not attempt to service or adjust the instrument unless another person,
capable of providing first aid or resuscitation, is present. Contact SDI for any
questions or repairs.
Operation
To operate the unit, locate the AC power entry connector on the rear panel and
connect the power cable. When power is applied to the unit, a red led located on
the front panel, labeled "on", should light up.
Copyright © SpectraDynamics, Inc. 1999
SDI
3