Switching Off - ANDILOG CENTOR WIRELESS II Instruction Manual

After the self-test, if the unit is functional, the Centor Wirless displays the measurement screen. It then
displays 0 N. A tare is performed when the device starts up.
If the force applied is greater than:
•
10% of maximum capacity, a warning message is displayed at start-up indicating the
percentage of force applied to the load cell. The force gauge can still be used, but we
recommend using accessories weighing less than 10% of the load cell's capacity.
•
At 20% of maximum capacity, the force gauge displays a maintenance screen. At the bottom
of this screen, the force applied in % is indicated. The unit cannot be used if the start-up force
is greater than 20%. In this case, switch off the force gauge and remove the preload before
switching it on again.
For example, for a force gauge with a capacity of 500N, the force applied to the load cell must not
exceed 100N at start-up.
Force applied at force gauge start-up (must be less
than 20%)
Value of the maximum force applied to the load
cell
Counter for the number of overloads applied to
the load cell
Displayed in orange if the next calibration date has
passed
Battery voltage
All settings are stored in memory when the force gauge is switched off. The force gauge will operate
with the same settings when switched back on (unit, display order).
3.2.
To switch off the Centor Wireless II, press and hold the
seconds).

Switching off

button until the instrument switches off (5
- 10 -
Instruction manual – 2.04
CENTOR WIRELESS II