Connection Status; Hardware; Software Versions - Aethra Vega X7 Use And Installation Manual

Connection Status

This section contains information about call status, including parameters such as incoming and outgoing
audio and video bandwidth, incoming and outgoing video frame rates, and protocols in use.
The "Connection status" page is displayed in a window overlaid on the current video. The "CANCEL" key
on the remote control can be used to change the transparency. To move within the table, press the "OK"
key, then use the up and down arrows keys to navigate. To exit the page, press the left arrow keys.
ISDN
In an ISDN call, you can check certain data about the connection: rate, audio encoding, video encoding,
frames/sec., and status of data channels.
In addition, by going to the "Accesses" icon and pressing OK, you can enter a page of advanced
diagnostics, used to monitor in greater detail the state of individual ISDN accesses.
For each access you can see whether it is configured or not, whether it is active or not, and for each single
access channel you can gain information such as the state, the number, cause of disconnection, "Error
H.221" messages, and the delay.
IP
For IP calls, you can check certain data related to the Audio and Video IP connection: bit rate, audio and
video encoding types, frames/packets (for audio), frames/sec. (for video), and number of lost packets.
NIC
For NIC calls you can check a series the following data about the connection: bit rate, audio and video
encoding types, frames/sec., and DATA channel status.

Hardware

This section contains basic hardware information such as internal temperature and MAC address.
Information about the processor and audio/video system can also be found in the Audio and Video
submenus.

Software Versions

This section shows contains information about the software modules installed on the system, including
versions, build dates, etc.
88