Control Panel; General; Screensaver - Aethra Vega X7 Use And Installation Manual

Control panel

In these pages you can configure some system parameters.

General

Screensaver

Remote control
General
Show Local Info:
If activated, shows information such as terminal name, ISDN number, and IP address on the
monitor in graphical form.
Show video name
If activated, allows visualization of the remote terminal "Name".
Show warnings:
If activated, allows visualization of "Bonding Recovery" messages.
Show logo when in a call:
Enables/disables logo display during a call. Logo is customizable—default is Aethra S.p.A.
Disable still picture:
disable transmission/receiving of "still images".
Send received still to TFTP server
Disable or enable and configure TFTP server (to obtain server IP address, please contact your
network administrator). If enabled, still images can be sent and stored in a TFTP (Trivial File
Transfer Protocol) server. These still images will be available for future use.
Enable startup jingle
If activated, allow the jingle to every reboot of the system.
Screensaver
Automatic screensaver:
to enable/disable the automatic screensaver function, and to set its timeout.
XGA on screensaver:
Enable/disable XGA loop function: "XGA IN" signal sent to "XGA OUT."
Two possible cases:
•
Active "XGA IN" signal: monitor shows XGA signal.
•
Inactive "XGA IN" signal: no signals on monitor ("Stand By" mode).
38