SWEEX MO300 - QUICK_START_GUIDE Manual page 3

English version
2. Connect the telephone cable (RJ-11) carrying the ADSL signal to the ADSL port at the rear of the modem. The LED
under ADSL will now start to blink. After approximately 30 seconds the LED will be lit continuously. In the event the
LED is not lit, check whether the splitter is properly connected and/or whether the ADSL line is ok.
3. Switch on the computer and connect it to the rear of the modem using a network cable (UTP RJ-45). You can select
any of the ports 1, 2, 3 and 4. The corresponding LED at the front of the modem will be lit. In the event the LED
fails to light up, check whether the network cable is properly connected to the computer and the modem.
Configuring the computer to connect to the modem
Windows Vista
In the bottom left of your screen, go to "Start" (Start) ‡ "Control Panel" (Control Panel).
Click on "View network status and tasks" (View network status and tasks).
Left in the column, click on "Manage network connections" (Manage network connections).
4