MULTIQUIP QP2TK Operation Manual page 18

STOPPING THE ENGINE (ELECTRIC START)
1. Place the engine speed control lever to the LOW
position and run for about 10 seconds.
2. Place the engine ON/OFF Stop lever in the OFF
position.
3. Turn the ignition key to the OFF position.
STARTING THE ENGINE (RECOIL START)
Refer to Figure 9.
1. Ensure the engine ON/OFF stop lever is not on the
OFF position.
2. Move the engine speed control lever to the LOW
position.
3. Ensure the ignition switch is in the OFF position.
4. Grasp the T-handle of the recoil cord assembly and pull
it briskly and smoothly for proper starting.
5. Once the engine starts, allow it to run for about 10
seconds before advancing the engine speed control
lever to the HIGH position.
CAUTION
ALWAYS run engine at full speed while pumping.
PAGE 18 — QP2TK TRASH PUMP • OPERATION MANUAL — REV. #4 (05/20/20)
EMERGENCY SHUTDOWN
1. To stop engine immediately, quickly place the ignition key
in the OFF position.
OPERATION