Nice DoubleSmart-Control Instructions And Warnings For Installation And Use page 14

11.3 - Notification command class
The device uses Notification Command Class to report different events to the controller using the Lifeline group (only in Root / Endpoint 1).
Table A7 - DoubleSmart-Control - Notification Command Class
Notification Type
System [0x09]
11.4 - Protection Command Class
Protection Command Class enables preventing local or remote control of the outputs.
Table A8 - DoubleSmart-Control - Protection Command Class
Type State
Unprotected – the device isn't protected and can be operated normally
Local 0
by the user interface.
No operation possible – button can't change the relay state, any other
Local 2
functionality is available (menu and Central Scenes Notification).
Unprotected – the device accepts and responds to all RF commands.
Local 0
No RF control – command class basic and switch binary are rejected,
Local 1
every other command class is handled.
14
Event
Heartbeat (Notification CC V5) [0x05]
Description
Parameter
–
Inputs connected with outputs.
Inputs disconnected from outputs.
Outputs can be controlled by Z-Wave®.
Outputs can't be controlled by Z-Wave®.
Status
0xFF – enable
(non-changeable)
Hint