Connection Configuration; Pppoe Configuration - D-Link DSL-504 User Manual

DSL-504 ADSL Router User's Guide

Connection Configuration

To establish the WAN connection, the Router must be configured to suit the
requirements of the ADSL connection protocol. This section discusses how to
configure the Router for the various connection types. Many ADSL users will use
the default method PPPoE, discussed below. If you are using an ADSL service
that employs an alternative connection method, namely, PPP over ATM
(RFC 2364) or "Bridged Ethernet" Multiprotocol Encapsulation over IP (RFC
1483), skip ahead to the section on Connection Type.

PPPoE Configuration

The default connection method used by the Router is PPPoE as defined by RFC
2516. Use the PPPoE Configuration window to set the VPI and VCI values and
enter your network account name and password. This window is also used to
terminate the WAN (PPP) connection.
To bring up the PPPoE Configuration window, click on the PPPoE Configuration
menu button and the following screen will appear:
PPPoE Configuration Window
30