Unist SmartFlow Instruction Sheet page 3

USB Backup and Restore Instruction Sheet
Figure 4. Unist SmartFlow® Controller Board Showing Communication Jumper
3. Then, access the Communication settings menu on the Unist controller. To enable
communications (Disabled by factory default), press on the
INPUT".
4. Then, set the control type to "Ethernet".
5. Lastly, touch the "IP: STATIC" button to the left which brings up the keypad to enter your IP
address.
Figure 5. Unist SmartFlow® Communication Settings
1137400
next to "RUN SIGNAL
Page 3