Delay Time - Yamaha CL1 Owner's Manual

8
TYPE
Drag the knob in the screen to select the HPF (High Pass Filter) or BPF (Band Pass Filter.)
9
Q
Adjust the Q level of the frequency range at which the key-in signal will activate the de-esser.
0
KEY IN SOURCE
The key-in signal is set to the SELF POST EQ.
❏ DELAY
2
1
ON
Turns the delay on/off of the currently selected channel.
2

Delay time

Drag the knob in the screen to adjust the delay time of the currently selected channel.
❏ INSERT (except for ST IN channels)
1
ON
Enables/disables insert-in/out.
2
OUT (Insert out)
Click this to select the output port that will be assigned to insert-out, from the following choices.
NONE
OMNI 1-OMNI 8
SLOT1-1, SLOT1-2...SLOT3-15, SLOT3-16
FX1L(A), FX1R(B)...FX8L(A), FX8R(B)
PR1L(A), PR1R(B)...PR8L(A), PR8R(B)
3
IN (Insert in)
Click this to select the input port that will be assigned to insert-in, from the following choices.
NONE
OMNI 1-OMNI 8
SLOT1-1, SLOT1-2...SLOT3-15, SLOT3-16
FX1L(A), FX1R(B)...FX8L(A), FX8R(B)
PR1L(A), PR1R(B)...PR8L(A), PR8R(B)
4
POINT (Insert point)
Selects the position at which insert-in/out will be patched. Choose from PRE EQ, PRE FADER, or POST ON.
1
2 3
No assignment
OMNI OUT jacks 1–8
Output channels of an I/O card installed in slots 1–3
L/R inputs of EFFETC rack 1–8
L/R inputs of PREMIUM rack 1–8
No assignment
OMNI IN jacks 1–8
Input channels of an I/O card installed in slots 1–3
L/R outputs of EFFETC rack 1–8
L/R outputs of PREMIUM rack 1–8
34
1
4
5
6
CL Editor Owner's Manual