Specifications; General Specifications - Yamaha CL3 Owner's Manual

Specifications

General specifications

Sampling Frequency
Signal Delay
Fader
Frequency Response
*4
Total Harmonic Distortion
*5
Hum&Noise
Dynamic Range
Crosstalk@1kHz
Dimensions (W x H x D)
and Net Weight
Power Requirements
(wattage)
Power Requirements
(voltage and hertz)
Temperature Range
Included Accessories
Optional Accessories
*1. Crosstalk is measured with a 30dB/octave filter @22kHz
*2. Excluded MBCL optional meter bridge.
*3. Refer to the Yamaha pro audio website for information on supported cards.
http://www.yamahaproaudio.com
*4. Total Harmonic Distortion is measured with 18dB/octave filter @80kHz
*5. Hum & Noise are measured with A-Weight filter.
European Models
Inrush Current based on EN 55103-1:2009
10A (on initial switch-on)
6A (after a supply interruption of 5s)
Conforms to Environments: E1, E2, E3 and E4
Specifications and descriptions in this owner's manual are for information purposes only. Yamaha Corp. reserves the right to
change or modify products or specifications at any time without prior notice. Since specifications, equipment or options may
not be the same in every locale, please check with your Yamaha dealer.
44.1kHz
Internal
48kHz
44.1kHz
+4.1667%, +0.1%, –0.1%, –4.0%
External
48kHz
+4.1667%, +0.1%, –0.1%, –4.0%
Less than 2.5ms, OMNI IN to OMNI OUT, Fs= 48kHz
100mm motorized, Resolution=1024steps, +10dB to –138dB, –∞dB all faders
+0.5, –1.5dB 20Hz-20kHz, refer to +4dBu output @1kHz, OMNI IN to OMNI OUT
Less than 0.05% 20Hz-20kHz@+4dBu into 600Ω, OMNI IN to OMNI OUT, Input Gain= Min.
–128dBu typ., Equivalent Input Noise, Input Gain= Max.,
–88dBu, Residual output noise, ST master off
112dB typ., DA Converter,
108dB typ., OMNI IN to OMNI OUT, Input Gain= Min.
*1
–100dB , adjacent OMNI IN/OMNI OUT channels, Input Gain= Min.
CL5: 1053mm x 299mm x 667mm, 36kg
*2
CL3: 839mm x 299mm x 667mm, 29kg
*2
CL1: 648mm x 299mm x 667mm, 24kg
CL5/CL3/CL1: 170W, Internal Power Supply
CL5/CL3/CL1: 200W, Simultaneous use of Internal PSU and External PW800W
US/Canada: 120V 60Hz
Japan: 100V 50/60Hz
China: 110-240V 50/60Hz
Korea: 220V 60Hz
Other: 110-240V 50/60Hz
Operating temperature range: 0-40°C
Storage temperature range: –20-60°C
Owner's Manual, Dust Cover, Power Cord
Meter Bridge MBCL (CL3/CL1 only), Mini-YGDAI cards
Power Supply PW800W, Power Supply Link Cable PSL360
±200ppm
±200ppm
*2
*2
*3
, Gooseneck Lamp LA1L
Specifications
55
Owner's Manual