Setting The Input Channels - Yamaha CL3 Owner's Manual

Patching the mixer output to the I/O rack
1.
Press the RACK button in the display screen,
then press the I/O RACK tab.
2.
Press the HA parameter area for the I/O rack
(that will be the output destination).
3.
Press the OUTPUT tab.
4.
Press the OUTPUT 1 button.
5.
In the PORT SELECT screen, select the output
channels you want to output to the rack.
6.
Press the CLOSE button.
7.
In the same way, set OUTPUT 2 and
subsequent outputs, if necessary.

Setting the input channels

Switching phantom power on or off
1.
Press the [SEL] key for the channel that you
want to control in the Channel Strip section
or Centralogic section.
2.
Press the GAIN knob in the SELECTED
CHANNEL section.
GAIN knob
3.
Press the +48V button in the GAIN/PATCH
popup window as necessary, depending on
the microphone you use.
➩
NOTE
The phantom power master switch on the I/O rack must be
turned on first.
Adjusting the analog gain
1.
Press the [SEL] key for the channel that you
want to control in the Channel Strip section
or Centralogic section.
2.
Press the [CUE] key of the same channel.
3.
While checking the sound level through the
headphones and meters, adjust the channel
[GAIN] knob of the Channel Strip section.
4.
Adjust the gain level for other channels in the
same way, by pressing their [SEL] and [CUE]
keys, and then rotating the [GAIN] knobs.
5.
After adjustment is complete, switch the
[CUE] key off (the key LED turns off).
Setting the input channels
41
Owner's Manual