Mixing With Cubase Ai - Yamaha Audiogram3 Owner's Manual

Quick Guide
Step 6

Mixing with Cubase AI

In this section we'll try mixing down multiple recorded audio tracks to stereo, and creating an
audio file. Mixes can be stored as WAV or AIFF files, which can then be recorded to audio
CDs.
1
Launch Cubase AI and open a project file.
2
Click the [Start] button on the Transport Panel.
3
While listening to playback, drag the channel strip level faders up and down to create
the desired initial balance, then adjust the overall volume using the bus volume fader.
4
Drag the pan controls on the top of the channel strips left and right to set the stereo
position of each track.
5
At this point you can begin to use EQ to refine your mix, and add effects.
As an example let's try adding reverb. Click the [Edit] button (
open the VST audio channel settings window. Click Inserts 1 and select "Reverb - RoomWorks SE."
For further details refer to the pdf manual provided with the Cubase AI software.
NOTE
It's a good idea to lower the channel fader a bit before adding an effect, since the effect
can cause an increase in the overall channel level.
CAUTION
16
AUDIOGRAM 3 Owner's Manual
) on the left side of the channel strip to