Multitech MultiConnect microCell User Manual page 27

1. Check signal strength.
Enter:
AT+CSQ
2. Verify device is registered on the cellular network.
Enter:
AT+CEREG?
Should return:
+CEREG: 0,1 or +CEREG: 0,5
OK
3. Activate context one
Enter:
Verizon:
AT#SGACT=3,1
Other Networks:
AT#SGACT=1,1
4. Set FTP operations timeout to 10 seconds
Enter:
AT#FTPTO=100
5. Configure FTP server IP address with username and password.
Enter:
AT#FTPOPEN="###.##.###.#","username","password",0
where ###.##.###.# is the IP address and the username and password for the FTP server.
6. Configure file transfer type.
Enter:
AT#FTPTYPE=#
where # is 0 for binary or 1 for ASCII.
7. If required, change the working directory to "folder1".
Enter:
AT#FTPCWD="folder1"
8. Enter the file name.
Enter:
AT#FTPGET="filename.txt"
where filename.txt is the file to download.
The device responds with:
CONNECT
The file is received through the device. The device responds with:
NO CARRIER
The data connection closes automatically when the file sending ends.
Closing the FTP Data Connection
After the file is sent:
1. Close the FTP connection.
®
MultiConnect microCell MTCM-L4N1D User Guide
S000822 Rev. 1.1
DEVICE CONFIGURATION
27