Comdial Executech 616 Installation & Programming Manual page 11

Introduction IMI 66-037
speed dial key on the key pad.)
If a particular line is not
programmed for selection as part of the auto or speed dial, the
prime line (if programmed) will be automatically chosen.
If the
prime line is unavailable or busy, the last line used to
originate a call will be chosen.
Other than the prime line or the auto/speed dial line selection,
automatic preselection of a line is not part of the system. A
line can be manually selected before lifting the handset (for
handsfree dialing) or after the handset is lifted.
The key pad
is automatically set for manual dialing when a manual line
selection is made.
hanual Hold
-./-'-'4'- -- -.m
A key activated feature at each station will place a PBX or TELCO
line on hold and provide music to the held party if an external
music source is connected to the system.
Pressing the HOLD key once effects a normal timed hold condition.
Any station which has access to the line can pick up the held
call. The normal hold condition will hold a call for a
programmed length of time. At the end of the first timeout
period, the line select indicator will flutter rapidly at all
stations and three quick tone bursts will sound at the holding
station. At the end of each subsequent timeout period, the
holding station receives an additional three quick tone bursts.
Each station provides programmable memory dialing features
available in a 14-key configuration. These memory keys can he
programmed to store numbers for automatic dialing purposes.
The
stored numbers can he up to 15-digits in length and can include
line or intercom selection, numbers, f's, *, pauses, and flash
signals. A pause is stored each time the HOLD key is pressed,
and a flash signal is stored each time the RECALL key is pressed.
The pause and flash intervals are programmable. Alternately,
memory location 14 can provide automatic, repetitive dialing of
the last number dialed if a memory number is not stored at that
location. I
Each station can be programmed to provide 10 speed dial numbers
at the keypad keys.
Speed dial numbers can be up to 15-digits in
length and also can include line or intercom selection, numbers,
#'s, "'s, pauses, and flashes.
In addition to the station speed
dial numbers, 10 system-wide speed dial numbers are available at
the keypad keys.
The system speed dial numbers can be up to 31
digits in length, and can include the same information as
described above. System speed dial programming can only be done
at station 10.