Comdial Executech 616 Installation & Programming Manual page 10

Introduction IMI 66-037
Flexible. Rinq,ing &s_.iqnment.s .lpel_a_yg&, Qis_gQl;e& S~b_&gdl
*%'-r'-ii - -- --- - -*
S---i-
Flexible ringing assignments are programmable on a per line/per
station basis.
The system can be configured to provide direct
ringing for every line at every station;
direct ringing for prime
line with delayed ringing for all other lines; and prime line
ringing only. Ringing can be disabled for each line on an
individual basis at each station.
Subdued ringing is
-
automatically provided to any station that is busy on an outside
line.
Hearing 512. .Co;patihl,e Handset
- .-'I - w'- ---m-9 ---'i-b-
The station handset is compatible with magnetically-coupled
hearing aids.
E Pold ,a_na 5 IJ_s;e Indic.a.t.ions
w-w- - - - .m: - - - i'- i
The light associated with the line select keys provide a visual
indication of the in-use and hold status of each line available
for use at a particular station.
Intercom Call Er_o_qr_e_s,s_ Tones
'A - -'m -.- w'- - - -'- mm---
Refer to the discussion titled, Tone 0.5 y,oi,e .Si,gna.l.linq
- - '- '... - - - - i'i'
(I.nte.rc.om)
,:,,,,,---L
Intercom Line .~,i~.$e.~.~.
-i-'-'---i -'i"-
Should the intercom line be selected with no subsequent action
taking place,
the system will timeout the active status and
return the station to an idle state.
Last Number. R.ed.ia.1
'- -4 '- i '- 'i's .s 'm - -----ms
Each station is equipped with a last number redial feature.
This
feature will save the last number manually dialed from the
keypad.
It will redial the saved number upon key command. A
newly dialed number will automatically replace a currently saved
number.
Line .P,resele,cti'o,n .(,Pri,m,e .Line)
-m-m --'m--i--i---
-ms--- -i-'-.-
If a station is programmed to include a prime line, this line
will be automatically selected for a manual dialing operation
when the handset is taken off hook. If the prime line is busy, a
manual line selection must be made.
Auto dial and speed dial numbers can be programmed to include any
particular line desired.
When this is done, an auto dial or
speed dial operation automatically selects that line for dialing.
Should that line be busy,
manual line selection must be made.
(If a line is selected manually for a speed dial call, either
station or system, press the HOLD/SHIFT key before pressing the
8