Recording; Basic Recording - Aiwa CX-NA71 Operating Instructions Manual

BASIC RECORDING
This section explains how to record from the tuner, CD player, or
external equipment.
Preparation
Set the tape to the point where recording will start.
Use Type I (normal) and Type
II
(high/CrOz) tapes for recording.
1 Insert the tape to be recorded on into deck 2.
Insert the tape with the side to be recorded onfirst facing
out from the unit.
2 Press the REV MODE button to select the reverse
mode.
To record on one side onry, select =.
To record on both sides, select Z> or C=).
3 Press the DOLBY NR button to turn Dolby NR on
or off.
\
'
To record with DOLBY NR, tury on U NR.
To record without DOLBY NR, turn off Do NR.
4 Press one of the function buttons and prepare
the
source to be. recorded.
'To record from a CD, press the CD button and load the
disc(s).
To record from a radio broadcast, press the TUNER button
and tune in to a station.
To record from the connected source, press the VIDEO/
AUX or MD buttpn and play.
5
Press the ~ REC/REC MUTE button to start
recording.
@
When the selected function is C,D, playback and recording
start simultaneously.
15
ENGLISH
To stop recording, press the button.
To pause recording, press the II button. (Applicable when the
source is TUNER, VI DEO/AUX or MD.) To resume recording,
press again.
INSERTING BLANK SPACES
Insertion of 4-second blank spaces enables you to activate the
Music Sensor function. (Applicable when the source is TUNER,
VIDEO/AUX or MD)
1 Press the REC/REC MUTE buiton during recording or
while in recording pause mode.
~ on the display flashes for 4 seconds and the tape runs
without recording. After 4 seconds, the deck enters the
recording pause mode.
2 Press the 11 button to resume recording.
To insert a blank space of less than 4 seconds, press the
REC/REC MUTE button again while ~ is flashing.
To insert blank spaces of more than 4 seconds, after the
deck enters recording pause mode, press the REC/REC
MUTE button again. Each time the button is pressed, a 4-second
blank space is added.
To erase a recording
Make sure the microphone is not connected to this unit.
1
Insert the tape to be erased into deck 2 and press the TAPE/
~ DECK 1/2 button to display "TP 2.
2
Set the tape to the point where the erasure is to be started.
3 Set the reverse mode by pressing the REV MODE button.
4 Press the REC/REC MUTE button to start the-erasure.