Advertisement
Advertisement
Table of Contents
Related Manuals for ATIGO A2300
Summary of Contents for ATIGO A2300
- Page 1 2-Wire Digital Video System Installation Manual Page | 1...
- Page 2 Wire up the system in accordance with the connected to a system powered by A2102 Wiring diagram supplied. Power supply. Make sure A2300 is installed next to the Maximum of 8 A1714 monitors can be Power supply when installing multiple connected to a system powered by A2101 Entrances.
- Page 3 DIP switch settings for A3101 Video camera module A3101 The video module is configured by 6 DIP switches. The DIP switches can be modified either before or after installation. Restarting the camera module is necessary whenever the DIP switches have been modified. DIP switches 1 and 2 are for addressing door stations.
- Page 4 Video module functions and Sound theme settings. programming In Standby, activate programming mode by setting DIP switch 6 to ON position. Press and hold Key A for 3 seconds to enter the Sound Theme Mode. The Status indicator will turn on and current theme sound, will play.
- Page 5 Electric lock mode settings Electric lock with additional power supply. In Standby, activate programming mode by setting DIP switch 6 to ON position. Contact rating is limited to 24V DC and MAXIMUM CURRENT of 1000mA. Press Key A, the Unlock Indicator will The jumper JP-LK must be taken off turn on with the warning sound of a long before connecting.
- Page 6 When triggering a gate, must use A2601 Electric lock powered by internal auxiliary relay. 12V DC output. NOTE: Do not connect Gate contacts to Video module as this will cause permanent Internal output is limited to 12V DC and module damage. MAXIMUM CURRENT of 200 mA.
-
Page 7: Programming Table
Programming Table Digital keypad module A3202 Digital keypad module is designed as a digital call module and as a stand-alone access control keypad for a secure PIN entry with up to 40 pin codes capacity. Use programming table for programming user pin codes and other functions and features. -
Page 8: Programming Tags
Delete specific user tags Digital display module A3203 In standby mode present MASTER CARD DELETE tag to card reader. Present user tag you wish to delete to card reader. Or use keypad to enter room number you wish to remove all user tags from and press # to confirm. -
Page 9: Backup And Restore
Backup and restore Restore to factory default Audio/Video module is design to store Caution! programmed information about user door When using this procedure all information will numbers, proximity tags and pin codes. be lost and modules restored to default All information stored by the module can be factory settings.
Need help?
Do you have a question about the A2300 and is the answer not in the manual?
Questions and answers