Page 1
2-Wire Digital Audio System Installation Manual...
Page 2
Maximum of 4 handsets can be connected to Introduction a single call button. The Atigo door entry system is a simple 2- wire solution that can be expanded up to 4 Maximum of 32 handsets can be connected in entrance panels and 32 handsets.
Page 3
DIP switch settings for A3200 The audio module is configured by 6 DIP switches. The DIP switches can be modified either before or after installation. Restarting the Audio module is necessary whenever the DIP switches have been modified. DIP switches 1 and 2 are for addressing door 1.
Page 4
Sound theme settings. In Standby, activate programming mode by Audio module functions setting DIP switch 6 to ON position. programming Press and hold “Touch Key A” for 3 seconds. The hourglass indicator will turn on and current theme will play. pressing “Touch key A”...
Page 5
Electric lock mode settings Electric lock with additional power supply. In Standby, activate programming mode by setting DIP switch 6 to ON position. Fail Safe Contact rating is limited to 24V DC and MAXIMUM CURRENT of 1000mA. Press “Touch key A”, the Door Open The jumper JP-LK must be taken off Indicator will turn on with a long Beep before connecting.
Page 6
Triggering a Gate automation: Electric lock powered by internal 12V DC output. When triggering a gate, must use A2601 auxiliary relay. NOTE: Do not connect Gate contacts to Internal output is limited to 12V DC and Video module as this will cause permanent MAXIMUM CURRENT of 200 mA.
Page 7
Programming Table Digital keypad module A3202 Digital keypad module is designed as a digital call module and as a stand-alone access control keypad for a secure PIN entry with up to 40 pin codes capacity. Use programming table for programming user pin codes and other functions and features.
Page 8
Delete specific user tags Digital display module A3203 In standby mode present MASTER CARD DELETE tag to card reader. Present user tag you wish to delete to card reader. Or use keypad to enter room number you wish to remove all user tags from and press # to confirm.
Backup and restore Restore to factory default Audio/Video module is design to store Caution! programmed information about user door When using this procedure all information will numbers, proximity tags and pin codes. be lost and modules restored to default All information stored by the module can be factory settings.
Need help?
Do you have a question about the A3200 and is the answer not in the manual?
Questions and answers