Parts and Functions Mounting Key functions The suggested installation height is LCD screen • Display the image of the visitor between 145~160 cm from ground. Up/Increase button • Press to increase the value Down/Decrease • button Press to decrease the value Setup button •...
Page 3
Main Menu Answering a call and door release When the Call button on the door entry panel is pressed, the monitor will start ringing and at the same time the image will be displayed on the screen Press Talk/Mon button on the monitor to start hands free communication which will last for a maximum of 90 seconds.
Page 4
Calling monitors in the same apartment /house: With the monitor in standby mode, press Setting button to enter Main Menu page Press Call/Unlock 2 button to enter Intercom page Press UP button to activate Inner Call All other monitors assigned to the apartment or house will ring at the same time, whichever answers the call first will establish the communication and all other monitors will stop ringing.
Basic Setup settings Door station call tone setting With the monitor in standby mode, press Setting button to enter Main Menu page Press Setting button again to enter Door Station Call Tone setting page Use UP/DOWN buttons to select the desired tone Doorbell tone setting With the monitor in standby mode, press Setting button to enter Main Menu page...
Tone volume setting With the monitor in standby mode, press Setting button to enter Main Menu page Press Setting button four times to enter Tone Volume setting page Use UP/DOWN buttons to select the desired volume Restore to default With the monitor in standby mode, press Setting button to enter Main Menu page Press Setting button five times to enter Restore to Default page...
Page 7
Change date / time & time zone With the monitor in standby mode, press Setting button to enter Main Menu page Press Setting button five times to enter Restore to default page Press and hold Unlock button for 3s Use Unlock, Call/Unlock 2 , UP and DOWN buttons to change the values Monitor parameter settings...
Page 8
Setting Slave monitors The system allows a maximum of four monitors per apartment or house, one Master monitor and three slave monitors. Each apartment must have at least 1 Master monitor in order to work correctly. To address extra Slave monitors, simply address the same code used by the Master monitor. Code 8000 should be used by the Master monitor, code 8001 by 1 Slave monitor, 8002 by 2 Slave...
Page 9
Setting the monitor code Each Master monitor on the system must have a unique identification code and this is set using DIP switches on the back of the monitors. • Bit-1 to Bit-5 are used to set the unique master monitor code with the value between 1 and 32 •...
Specifications Power supply 20~28V DC Power consumption Standby 0.2W; Working 6W Monitor screen 7” digital colour LCD Display resolutions 800 x 480 pixels Video signal 1Vp-p, 75Ohm, CCIR standard Wiring 2-wires non polarised Dimensions 161 x 173.5 x 18 mm (HxWxD) Precautions All components should be protected from vibrations and not suffer any impact.
Need help?
Do you have a question about the A1701 and is the answer not in the manual?
Questions and answers