Setting The Auto Standby Function - Onkyo A-9070 Instruction Manual

Setting the Auto Standby Function

When the Auto Standby (ASb) function is activated, the
integrated amplifier will automatically enter Standby
mode if there is no operation for 30 minutes with no audio
signal input.
■
Operating with the remote controller
SETUP
1
Press SETUP.
2
Press !/" repeatedly to select "ASb".
3
Press ENTER.
The current setting is displayed.
4
Press #/$ to switch between "ASb-ON" and
"ASb-OFF".
ASb-ON:
Enables Auto Standby.
ASb-OFF:
Disables Auto Standby.
The setting is automatically confirmed.
5 Press RETURN repeatedly to exit the setup.
Once the Auto Standby (ASb) function has been activated,
the integrated amplifier will not automatically turn on
even if it receives a signal. To turn on the integrated
amplifier, press 8ON/STANDBY on the integrated
amplifier or 8 on the remote controller manually.
En
38
■
Operating on the integrated amplifier
!/"/#/$
ENTER
RETURN
1 Press SETUP repeatedly to select "ASb".
2
Use the INPUT selector to switch between
"ASb-ON" and "ASb-OFF".
First, the current setting flashes on the information
display. Then, the setting is switched ON/OFF.
The setting is automatically confirmed.
3 Press SETUP repeatedly to exit the setup.
Tip
• Depending on the countries, the default setting is ON (European
models) or OFF (North American models).
Note
• When the Auto Standby (ASb) function is activated, Onkyo
components connected via u are automatically turned off
(➔ page 20).
• Before entering Standby mode with the Auto Standby (ASb)
function, the message "ASb" flashes for 30 seconds on the
information display.
• The integrated amplifier will end the setup if there is no
operation for 8 seconds.
INPUT selector
SETUP