Switching The Power Meter Range; Setting Auto Standby (Asb) - Onkyo M-5000R Instruction Manual

Switching the Power Meter Range

x 1, x 10
Off LED METER RANGE
You can switch the power output of speaker terminals
between ×1 (default) and ×10 (10 times).
1 Press METER RANGE repeatedly to switch
METER RANGE in the following order:
×1 (default), ×10, Off
The x 1, x 10 LEDs and the Off LED will light
according to the set status of METER RANGE.
The number of watts indicated on the meters corresponds
to the actual output level when driving speakers rated at 8
ohms. When driving speakers rated at 4 ohms, the output
is actually twice that shown on the power meters.

Setting Auto Standby (ASb)

AUTO STANDBY
When AUTO STANDBY is turned ON side, the power
amplifier will automatically enter Standby mode if the
power amplifier receives no signal for 3 hours.
1 Set ON/OFF by switching the AUTO STANDBY
switch.
ON:
ASb enabled.
OFF:
ASb disabled.
Default setting: ON (European models), OFF (North
American models)
Once the ASb function has been activated, the power
amplifier will not automatically turn on even if it receives
the signal. To turn on the power amplifier, press
ON/STANDBY manually. You can also disable the
function by setting this switch to OFF side.
Note
• Before entering standby mode with the Asb function, the Off
LED flashes 30 seconds before the ASb function starts running.
En
21