Advanced Operations; Custom Setup; Setting The Trigger; Setting The Auto Standby Function - Onkyo M-5010 Owner's Manual

Advanced Operations

Custom Setup

Setting the TRIGGER

Make TRIGGER selector settings if you want to turn the
power on and off along with other equipment.
TRIGGER selector
1 Switch the TRIGGER selector on the unit's rear
panel.

[12V TRIGGER]
The M-5010 will be turned on when the 12V
TRIGGER jacks are provided with power.

[AUDIO]
The M-5010 will be turned on when the INPUT
jacks are provided with an audio signal.
Note:
The power will not be turned off automatically
if the TRIGGER selector is set to AUDIO.
Use the Auto Standby function if you want to
turn off the power automatically.

[OFF] (default)
Set the TRIGGER selector to OFF if you want
to turn the M-5010 on or off independently
from other equipment.

Setting the Auto Standby Function

When the Auto Standby (ASb) function is activated, the
power amplifier will automatically enter Standby mode if
there is no operation for 3 hours with no audio signal
input.
AUTO STANDBY selector
1
Switch the AUTO STANDBY selector on the unit's
rear panel.

[ON]
Enables auto standby.

[OFF] (default)
Disables auto standby.

Setting the Speaker Impedance

You can set the impedance of the speakers that you
connect to the unit.
SPEAKER IMPEDANCE selector
1
Switch the SPEAKER IMPEDANCE selector on
the unit's rear panel.
[4  or more and less than 8 ]

Sets the impedance to 4 .
[8  or more and 16  or less]

Sets the impedance to 8 . (default)
Caution
• Settings will not be enabled even when the selector is changed in
the Standby mode.
To change a setting, be sure to turn on the unit prior to making
any changes.
En
9