Botex DPX-1210T NET User Manual page 8

Safety instructions
DANGER!
Risk of death from electrical current!
Hazardous voltage may be present at cable ends and screw terminals. The connection of screw terminals and all maintenance and
repair work on the electrical installation of the device may only be performed by a qualified electrician. Always perform maintenance
and repair work when the device is free from voltage. Failure to comply may result in electric shock and risk of fire and loss of life.
Always observe all electrical safety instructions applicable in the country of operation.
NOTICE!
Risk of fire due to covered vents and neighbouring heat sources!
If the vents of the device are covered or the device is operated in the immediate vicinity of other heat sources, the device can over‐
heat and burst into flames. Never cover the device or the vents. Do not install the device in the immediate vicinity of other heat
sources. Never operate the device in the immediate vicinity of naked flames.
NOTICE!
Damage to the device if operated in unsuitable ambient conditions!
The device can be damaged if it is operated in unsuitable ambient conditions. Only operate the device indoors within the ambient
conditions specified in the "Technical specifications" chapter of this user manual. Avoid operating it in environments with direct sun‐
light, heavy dirt and strong vibrations. Avoid operating it in environments with strong temperature fluctuations. If temperature fluc‐
tuations cannot be avoided (for example after transport in low outside temperatures), do not switch on the device immediately.
Never subject the device to liquids or moisture. Never move the device to another location while it is in operation. In environments
with increased dirt levels (for example due to dust, smoke, nicotine or mist): Have the device cleaned by qualified specialists at reg‐
ular intervals to prevent damage due to overheating and other malfunctions.
NOTICE!
Damage to the device due to high voltages!
The device can be damaged if it is operated with the incorrect voltage or if high voltage peaks occur. In the worst case, excess vol‐
tages can also cause a risk of injury and fires. Make sure that the voltage specification on the device matches the local power grid
before plugging in the device. Only operate the device from professionally installed mains sockets that are protected by a residual
current circuit breaker (FI). As a precaution, disconnect the device from the power grid when storms are approaching or it the device
will not be used for a longer period.
DPX-1210T NET
8
Dimmer Pack