Brush Roll - Shark POWERDETECT RV2800AE Owner's Manual

MAINTENANCE
CLEANING THE WALL-FOLLOW SENSORS
1. The sensors on the robot require occasional maintenance.
2. With a dry cloth or cotton swab, gently dust off the sensors located on the sides of the robot.
CLEANING SIDE BRUSH
CLEAN SIDE BRUSH AS NEEDED.
NOTE: Remove and replace any side brush that is bent or damaged. To remove a brush, lift it off its peg.
Carefully unwind and remove any string or hair
wrapped around brush.
Gently wipe brush with a dry cloth. To reinstall, snap
the brush over the peg. Spin the brush manually to
make sure it is installed correctly.
s h a r kc l e a n . c o m
MAINTENANCE
To access the brushroll, push up on the tabs on the
brushroll door, then lift off the door.
Take out the brushroll and remove the cap on the
end. Clean off any hair or debris then replace the
cap.
NOTE: Replace brushroll every 6 to 12 months, or when visibly worn. See sharkaccessories.com for replacement parts.
s h a r kc l e a n . c o m
BRUSHROLL
Reinstall the brushroll, inserting the flat end first.
Close the brushroll access door and press down until
both sides click into place.