Maintenance - Shark POWERDETECT RV2800AE Owner's Manual

MAINTENANCE

MAINTAINING THE BASE DUST BIN
Depending on the size of the base, empty the base
dust bin every 30 to 60 days or as needed.
To detach the bin, press the Dust Bin Release
button on the top of the base then slide out the
bin.
CLEANING AND REPLACING THE BASE FILTERS
Regularly clean the filters to keep your vacuum's suction power optimal. Replace filters every 6-12
months or as needed.
IMPORTANT: DO NOT use soap when cleaning the filters.
CLEAN PRE-MOTOR FILTERS ONCE A MONTH
To open the filter housing lid, hold the top left edge of
the base and pull up on the lid. With the lid open, remove
the foam filter by the top handle, then lift out the felt filter
underneath. Tap the filters clean over the trash, then rinse
with cold water ONLY, as soap may damage them. Allow
filters to air-dry completely before reinstalling them. The
filters must be installed correctly for the base to work
properly. Reinsert the felt filter first, then the foam filter.
s h a r kc l e a n . c o m
To empty the bin, hold it over the trash, then press
the release button with the trash can icon on the
side of the bin. The bin lid will open, releasing
dust and debris. Lightly tap the dust bin against
the inside of the trash receptacle to knock off any
remaining debris. Reinstall the bin by sliding it into
the slot in the base until it clicks into place.
CLEAN
POST-MOTOR
FILTER ONCE
A MONTH
Press the
button at the
top of the
Filter Door,
then tilt the
door and lift
it off. Remove
the Post-
Motor Filter
from the base
by pulling the
tab down.
Tap the filters
clean over the trash. Do not use water or soap to
clean filters as this will cause damage.
MAINTENANCE
CAUTION: Turn off power before performing any maintenance. To turn the
robot power off, press the DOCK button on the robot for 5-7 seconds.
EMPTYING THE ROBOT DUST BIN
Press the Dust Bin Release Button and slide out the
dust bin.
Empty debris and dust into trash. If desired, you
may use a damp cloth to wipe the dust bin. Let dry
for 24 hours before use.
NOTE: After emptying the dust bin make sure to insert
the dust bin completely, until it clicks into place.
To open the dust bin lid, pinch and lift up using the
finger slots.
s h a r kc l e a n . c o m