Shark Powered Lift-Away NV751 Quick Start Manual

Please be sure to read the enclosed Shark® Owner's Guide prior to using your unit.
QUICK START GUIDE
WHAT'S INSIDE
A Motorized Floor Nozzle
B Wand
C Handle
D Pet Multi-Tool

ASSEMBLY

B
1
(Click)
A
Insert wand into
motorized floor nozzle.
3
(Click)
Place pod onto wand and
slide down to connect.
NV751_QSG_170329
POWERED
LIFT-AWAY ®
E Hard Floor Hero™ Attachment
F Crevice Tool
G Pet Power Brush
C
2
(Click)
Insert handle into wand.
4
(Click)
D
F
Connect hose to back of
pod, pressing until it clicks
into place. Store accessories
on the posts on the pod.

MAINTENANCE

Empty dust cup after each use
Pull up on Hold dust cup over a
trash bin and press the
dust cup
release latch empty-release latch
and lift dust on the bottom.
cup off pod.

Cleaning Filters

Foam filter
Filter
Felt filter
HEPA
Pre-Motor (foam and felt):
With the dust cup removed, take out and rinse the foam and
felt filters with water.
Post-Motor (HEPA):
To access the HEPA filter, reach under the grill and pull the
Filter Access latch to remove the grill. Remove and rinse the
HEPA filter.

Easy brushroll maintenance

E
Use a coin to A portion of the base
open the 3 is hinged for better
G
locks on the access to the brushroll
bottom of the and exposure to the
floor nozzle. airway. To reassemble,
replace base by lining
it up along the front
nozzle. Rotate closed
and lock the 3 locks.
Press top dust-
cup release latch
to access dust
screen and remove
built-up debris
as required.
TIP:
Wash filters every
3 months to keep
the suction strong.
Rinse filters and allow
to air-dry completely.
Tap loose dirt from
foam filters as needed
between washes.
Remove any
string, carpet
fibers, or hair
that may be
wrapped around
the brushroll.