Rexton BiCore Custom Li ITC Manual For Hearing Care Professionals

Rexton BiCore Custom Li ITC Manual For Hearing Care Professionals

Advertisement

Quick Links

BiCore Custom Li ITC/ITE
GUIDE FOR HEARING CARE PROFESSIONALS
RX_BiCore_Custom_Li_ITC_Dispenser_EN.indd 1
RX_BiCore_Custom_Li_ITC_Dispenser_EN.indd 1
01-12-2021 10:30:02
01-12-2021 10:30:02

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BiCore Custom Li ITC and is the answer not in the manual?

Questions and answers

Summary of Contents for Rexton BiCore Custom Li ITC

  • Page 1 BiCore Custom Li ITC/ITE GUIDE FOR HEARING CARE PROFESSIONALS RX_BiCore_Custom_Li_ITC_Dispenser_EN.indd 1 RX_BiCore_Custom_Li_ITC_Dispenser_EN.indd 1 01-12-2021 10:30:02 01-12-2021 10:30:02...
  • Page 2: Table Of Contents

    CONTENT Introduction    Fitting    Assembling    Activating    Charging    Connecting    Noting the serial number    Important safety information    Defective power cells    Further information    Storage periods    Explanation of symbols    RX_BiCore_Custom_Li_ITC_Dispenser_EN.indd 2 RX_BiCore_Custom_Li_ITC_Dispenser_EN.indd 2 01-12-2021 10:30:02 01-12-2021 10:30:02...
  • Page 3: Introduction

    INTRODUCTION This guide is intended for Hearing Care Professionals. It provides important information on hearing instruments  with permanently built-in power cells (lithium-ion batteries). CAUTION It is important to read this guide, the user guide and the safety manual thoroughly. Follow the safety information to avoid damage or injury. RX_BiCore_Custom_Li_ITC_Dispenser_EN.indd 3 RX_BiCore_Custom_Li_ITC_Dispenser_EN.indd 3 01-12-2021 10:30:02...
  • Page 4: Fitting

    FITTING You must prepare the hearing instruments before you  can start fitting. ASSEMBLING A power cell is installed in every hearing instrument on  delivery. There is no need to insert a battery. ACTIVATING Before first use or first fitting, you must activate the  hearing instruments. Place the hearing instruments  in the charger (if they are not already inserted) and press the charger's button until the LEDs for the hearing instruments light up green. Note: ■  Hearing instruments that are activated and not used may discharge faster than hearing instruments ...
  • Page 5: Charging

    CHARGING Charge the hearing instruments for at least 15 minutes  before a first fitting session. Fully charge the hearing instruments before delivery  to the client. A full charging cycle takes approximately 4 hours. Follow the operating conditions in both the hearing instrument's and the charger's user guide. CONNECTING Use Noahlink Wireless to fit the hearing instruments  wirelessly. NOTING THE SERIAL NUMBER The serial number is printed on the backside of the device. RX_BiCore_Custom_Li_ITC_Dispenser_EN.indd 5 RX_BiCore_Custom_Li_ITC_Dispenser_EN.indd 5 01-12-2021 10:30:02...
  • Page 6: Important Safety Information

    IMPORTANT SAFETY INFORMATION This section contains important safety information regarding the power cell. For more safety information, refer to the safety manual and the user guide supplied with the hearing instruments. NOTICE Do not exchange power cells. This may only be performed by Service Center. DEFECTIVE POWER CELLS In case you think the power cell is defective, comply with the following steps:...
  • Page 7 cannot be shipped anymore. Please record the serial number of the hearing instrument, take a photo of  the damages, and consult with the Customer Service  team before disposal of the product according to local regulations. RX_BiCore_Custom_Li_ITC_Dispenser_EN.indd 7 RX_BiCore_Custom_Li_ITC_Dispenser_EN.indd 7 01-12-2021 10:30:02 01-12-2021 10:30:02...
  • Page 8: Further Information

    FURTHER INFORMATION STORAGE PERIODS Unused hearing instruments lose their charge. Observe  the following storage periods to avoid deep-discharge: ■  Hearing instruments that have not been activated or  used can be stored up to 12 months after production  date. The production date is printed on the hearing instrument's label on the packaging. ■  Once a hearing instrument is activated, in order for it  to remain in good condition it needs to be charged at least every 6 months. EXPLANATION OF SYMBOLS Symbols used in our documents Points out a situation that could lead to serious, moderate, or minor injuries.
  • Page 9 Symbols used in our documents Indicates the legal manufacturer of the device. "Made for iPhone", "Made for iPad", and "Made for iPod" mean that an electronic accessory has been designed to connect specifically to iPhone,  iPad, or iPod, respectively, and has been certified by the  developer to meet Apple performance standards. Apple  is not responsible for the operation of this device or its compliance with safety and regulatory standards. Please ...
  • Page 10 Symbols on the device or packaging Keep dry during transportation. Temperature during transportation. Read more in section  "Operating, transport and storage conditions". Relative humidity during  transportation. Read more in section  "Operating, transport and storage conditions". Atmospheric pressure during transportation. Read more in section  "Operating, transport and storage conditions". Medical device. Bluetooth low energy technology. ® RX_BiCore_Custom_Li_ITC_Dispenser_EN.indd 10 RX_BiCore_Custom_Li_ITC_Dispenser_EN.indd 10 01-12-2021 10:30:02 01-12-2021 10:30:02...
  • Page 11 RX_BiCore_Custom_Li_ITC_Dispenser_EN.indd 11 RX_BiCore_Custom_Li_ITC_Dispenser_EN.indd 11 01-12-2021 10:30:02 01-12-2021 10:30:02...
  • Page 12 Legal Manufacturer WSAUD A/S Nymøllevej 6 3540 Lynge Denmark Document No. 04912-99T01-7600 EN Order/Item No. 210 168 77 Master Rev01, 11.2021 © 12.2021, WSAUD A/S. All rights reserved 0123 www.rexton.com RX_BiCore_Custom_Li_ITC_Dispenser_EN.indd 12 RX_BiCore_Custom_Li_ITC_Dispenser_EN.indd 12 01-12-2021 10:30:02 01-12-2021 10:30:02...

This manual is also suitable for:

Bicore custom li ite

Table of Contents