Advertisement
Quick Links
Ergo Electric Standing Desk 54x26
Holds up to
2 People Required
200 lb (90.7 kg)
Box 1 of 2 - Top
*Desktop and leg kit ship in separate boxes and could arrive in separate deliveries.
Patent and trademark information: vari.com/patents | ©2022, 2023 Varidesk, LLC All rights reserved.
x2
x1
Box 2 of 2 - Legs
x1
M10
x1
M6
x2
x2
x4
M10
40mm
x4
x4
M6
14mm
M6
x1
x1
Advertisement
Related Manuals for Vari Ergo Electric Standing Desk 54x26
Summary of Contents for Vari Ergo Electric Standing Desk 54x26
- Page 1 Box 1 of 2 - Top Box 2 of 2 - Legs 40mm 14mm *Desktop and leg kit ship in separate boxes and could arrive in separate deliveries. Patent and trademark information: vari.com/patents | ©2022, 2023 Varidesk, LLC All rights reserved.
-
Page 2: Product Assembly
Product Assembly Desktop and desk legs will arrive in separate boxes. We recommend assembling the desk with the desktop face down in its box to prevent any surface scratching. Open both boxes; remove the desk legs and parts from their box. Place the legs into the grooved areas on each side of the metal frame. - Page 3 AC = Power Cord AC = Power Cord M1 = Leg Cable M1 = Leg Cable M2 = Leg Cable M2 = Leg Cable HS = Control Panel HS = Control Panel Once the legs are secured with screws and while the desk is sti ll face down, lower the control box into the middle cavity of the metal frame.
- Page 4 Once the control box is secure and while the desk is sti ll face down, place one foot on top of one leg aligning the screw holes. Use the larger hex key (M10) provided to securely ti ghten screws (M10 - 40mm) into the feet. Repeat this step to att ach the other foot. PLEASE NOTE: A cable tray is available for purchase as an added accessory.
-
Page 5: Initial Setup
Product Setup & Adjustments Initial Setup Press the DOWN butt on on the control panel unti l the base reaches its lowest positi on. Press and hold the DOWN butt on again unti l the LED display reads “RST”. Press and hold the 1 butt on (about 5 seconds) while the LED fl ashes “RST” and switches to either: 10.1 = One-Touch (preset butt ons work with one quick press) 10.2 = Constant-Touch (preset butt ons work when pressed and held down for a few seconds) Release the 1 butt on. - Page 6 Highest Setting Prefered Lowest Setting Lowest Setting Setting Upper & Lower Limits The height setti ngs range from 25-50.5 inches (63.5-128 cm). If you prefer to change the setti ngs to a more narrow range, follow the below steps. Make sure the power is ON and a number reads on the LED display (if no number appears, please follow the Troubleshooti ng and Reset procedure).
-
Page 7: Control Panel Lock
If the legs are rising slowly, check the input power connecti on to make sure it’s secured correctly. If any errors conti nue, please contact Vari. -
Page 8: Troubleshooting Solution
M2 port is not fully secured. Disconnect and reconnect the cable. Follow below instructions to reset (RST) the desk. If error persists, contact Vari. If the desk is raised and lowered continously for more than 2 minutes, it will display this code Motor Overuse and cease working temporarily to protect the mechanism from overheating.
Need help?
Do you have a question about the Ergo Electric Standing Desk 54x26 and is the answer not in the manual?
Questions and answers