Ecom xRE Operation Manual page 5

Initiation/Measurement
Set burner control units to diagnostic mode
NOTICE
Applies only to Siemens burner controls!
Burner control in operating position:
Press reset button for at least 3 seconds.
Burner control in Lockout position:
Press reset button for at least 3 seconds.
Press reset button again for at least 3 seconds.
Read out burner control
1. Set ecom xRE to the interference suppression button.
2. Enable ecom xRE by pressing the setting key.
NOTICE
When using the Satronic or Siemens PC software, hold down the
setting key until PC mode appears on the display.
When using the AK PC software, the ecom xRE must not be started
in PC mode.
3. ecom xRE searches for automat information.
NOTICE
ecom xRE switches off after 2 minutes if it does not detect any signal.