Extended Command 0X030D - Read Date And Time - Magtek mDynamo Programmer's Manual

7 - Commands

7.4.15 Extended Command 0x030D - Read Date and Time

Like all extended commands, the host initiates this command by calling Command 0x49 - Send
Extended Command Packet (Extended Commands Only), and receives a response as documented
there.
The host uses this command to get the date / time from the device's internal clock. See Extended
Command 0x030C - Set Date and Time (MAC).
Request Data: None
Table 7-38 - Response Data for Extended Command 0x030D - Read Date and Time
Offset Field Name
0 Month
1 Day
2 Hour
3 Minute
4 Second
5 Unused
6 Year
Result codes:
0x0000 = Success
0x0396 = Invalid Date / Time data (Date / Time has not been set yet)
Example Request (Hex)
Command Number
Data Length
Extended Data Offset
Extended Command Number
Complete Extended Data Length
Extended Data
Example Response (Hex)
Result Code
Data Length
Extended Data Offset
mDynamo| OEM Secure Card Reader Authenticator | Programmer's Manual (COMMANDS)
Value from 0x01..0x0C
Value from 0x01..0x1F (less depending on month)
Value from 0x00..0x17
Value from 0x00..0x3B
Value from 0x00..0x3B
0x00
Value from 0x00 (2008)..0xFF (2263)
Header
49
06
Data
0000
030D
0000
Not Applicable
Header
0A
0D
Data
0000
Page 88 of 167 (D998200151-200)
Value