Property 0X10 - Interface Type - Magtek mDynamo Programmer's Manual

8 - Properties
8.9

Property 0x10 - Interface Type

0x10
Property ID:
Property Type: Byte
Length: 1 byte
Get Property: Yes
Set Property: Yes (No for devices that switch connections automatically)
Default Value: 0x00
This property represents the device's current connection type (see section 2 Connection Types) and data
format (see section 3 Data Formats):
•
Valid values for this property are
o 0x00 = USB HID (HID Only)
•
On devices that have only one possible value for this property, the property is read-only.
•
On devices that support multiple values for this property and do not handle connection switching
automatically, the host can use this property to change the device's behavior. MagTek strongly
recommends the host set this property before setting other properties, and immediately power cycle or
reset the device (see Command 0x02 - Reset Device), because it changes which other properties are
available.
This property is stored in non-volatile memory, so it persists when the device is power cycled. When this
property is changed, the device must be reset (see Command 0x02 - Reset Device) or powered off for at
least 30 seconds, then powered on, before the changes will take effect.
Example Set Request (Hex)
Cmd Num
01
Example Set Response (Hex)
Result Code
00
Example Get Request (Hex)
Cmd Num
00
Example Get Response (Hex)
Result Code
00
mDynamo| OEM Secure Card Reader Authenticator | Programmer's Manual (COMMANDS)
Data Len
02
Data Len
00
Data Len
01
Data Len
01
Page 112 of 167 (D998200151-200)
Property ID
10
Data
Property ID
10
Property Value
00
Property Value
00