General Commands; Command 0X00 - Get Property - Magtek mDynamo Programmer's Manual

7 - Commands
7.3

General Commands

7.3.1 Command 0x00 - Get Property

This command gets a property from the device. For details about properties, see section 8 Properties.
Most properties have a firmware default value that may be changed during manufacturing or the order
fulfillment process to support different customer needs.
Table 7-4 - Request Data for Command 0x00 - Get Property
Data Offset
0
Table 7-5 - Response Data for Command 0x00 - Get Property
Data Offset
0..n
Property ID is a one-byte value that identifies the property. A full list of properties can be found in
section 8 Properties.
Property Value consists of the multiple-byte value of the property. The number of bytes in this value
depends on the type of property and the length of the property. Table 7-6 describes the available property
types.
Table 7-6 - Property Types
Property Type
Byte This is a one-byte value. The range of valid values depends on the property.
This is a null-terminated ASCII string. Its length can be zero to a maximum
String length that depends on the property. The length of the string does not include the
terminating NULL character.
The result codes for the Get Property command can be any of the generic result codes listed in Table 7-3
on page 42.
mDynamo| OEM Secure Card Reader Authenticator | Programmer's Manual (COMMANDS)
Property ID
Property Value
Description
Page 43 of 167 (D998200151-200)
Value
Value