No Tcp/Ip; Printer Not Found - Kodak ESP 7 ALL-IN-ONE PRINTER User Manual

Bottom light
To establish an active network connection
1
Check the cable connections from the All-in-One printer to your gateway, router, or hub
to ensure connections are secure.
2 If the connections are secure, turn off the power on the All-in-One printer, and then turn
it on again. Press the
press it again to turn it back on. Also, turn off the power on your router or hub, and then
turn it on again.

No TCP/IP

Probable Cause
Your Local Area Network (LAN) card is not installed properly.
Corrective Action
Make sure your LAN card is installed properly and set up for TCP/IP. See the instructions
that came with your LAN card.

Printer not found

Probable Cause 1
The All-in-One printer is not turned on.
Corrective Action
Turn on the printer.
Probable Cause 2
You do not have an active network connection.
Corrective Action
Make sure you have an active network connection.
To make sure your network connection is active
1 If the connections are secure, turn off the power on the All-in-One printer, and then turn
it on again. Press the
press it again to turn it back on. Also, turn off the power on your router or hub, and then
turn it on again.
2 Check the cable connections from the printer to your gateway, router, or hub to ensure
connections are secure.
3 Make sure the printer is connected to the network with a CAT-5 or better Ethernet
cable.
Kodak ESP 7 Printer User Guide
This yellow light flashes when data is being sent or received by the
device over the network.
On/Off
button on the control panel to turn the printer off, and
On/Off
button on the control panel to turn the printer off, and
Chapter 9
87