Connecting To An Unlisted Network - Kodak ESP 7 ALL-IN-ONE PRINTER User Manual

Setting Up Your Printer
8 After completing your entry, select the
The LED will be continuously lit when you are connected to a wireless network. This does
not guarantee you are connected. You must verify that you are connected. See "Verifying
network configuration" on page 30.

Connecting to an unlisted network

Wi-Fi Setup Wizard
1
2 If your network does not appear in the list and is configured to not broadcast its SSID,
Unlisted Network
select
3
Follow the prompts to enter the network name using the keyboard visible on the LCD
screen. Press
using the same upper and lower case letters as your SSID. After completing your entry,
DONE
select
WEP
4 Select
OK
.
5 Enter the security information required using the LCD screen keyboard.
•
Press
characters. Then select
28
Key/Passphrase/
Security String
WEP Key
WPA /WPA2 phrase
LED Status
Fully Lit
Blinking
is the first option; press
and press
, , or
OK
, and then press
WPA/WPA2
or as required for your network's security setup, and then press
, , or to select a key. Select
DONE
Description
5 or 13 ASCI characters; case-insensitive
or
10 or a 26 Hexidecimal digits; case-insensitive.
8-63 printable ASCI; case-sensitive characters.
DONE
key, and then press
Description
When lit, signals that a wireless (Wi-Fi) network
connection has authenticated to the router, but
your connection may not be active. You can
verify the connection through the Network
Settings menu.
Blinks when
•
searching for an available Wi-Fi network
within range
•
existing signal is too weak to transmit
The LED has a repetitive cycle of blinking, then
resting for 15 seconds, followed by blinking
again. The Wi-Fi radio will continue to attempt
connection to the network until a connection is
established.
OK
to select it.
OK
.
to select a key. Enter the alphanumeric string accurately,
.
<BKSP
OK
and press .
OK
.
to erase any incorrect
Kodak ESP 7 Printer User Guide